Oil vapour removal filter from Hankison. For removal of oil and hydrocarbon vapours normally adsorbable by active carbons. Removes solid particles to 0.01 micron (0.003 mg/m3 maximum remaining oil content as a vapor). Features corrosion resistant inner and outer cores.
This filter is designed to be used downstream of high efficiency oil removal filters.
Features Two Stage Filtration as follows:
First Stage - A stabilised bed of finely divided carbon particles removes the majority of the oil vapour.
Second Stage - Multiple layers of fibre media with bonded micro fine carbon particles remove the remaining oil vapour. Multiple layers of fine media prevent particle migration. Outer coated, closed cell foam sleeve prevents particle migration.
Designed for 1000 hour life at rated conditions based on inlet temperature of +20 deg C.
This dryer does not reduce CO/CO2 or other noxious gases or vapours.
To optimise the life of the filter install a series HF as a pre-filter.
These filters conform to ISO Quality Standard 8573-1:1995. Please refer to the attached data sheet for a full explanation.
To find the maximum flow at pressures other than 7 bar, please consult the pressure correction table at the end of the attached datasheet.
All filters are supplied with a differential pressure gauge. Automatic drains are included up to F17-B-CF only.
Filters are available with connection sizes of 1/4" BSP to 3" BSP and DN 80 to DN 150 flange.
Element(s) is(are) included with the filter. Larger filters require more than one element.
To order spare elements please use the link below and the part number and qty shown. For example: CF-08 x 1 means 1 off element part number CF-08 is required for this filter.
This range supersedes HF1 filter from Hankison which has been discontinued (March 2010).
A modular connection kit for joining two filters and a wall mounting bracket can be ordered separately.
